0.96 Inch OLED Display Module I2C 128x64 SSD1306 (White)

Add a crisp, readable user interface to your electronics project with this 0.96 inch White OLED Display Module based on the popular SSD1306 controller. The module uses a 128 x 64 pixel monochrome OLED panel, so every pixel emits its own light and no separate backlight is required. This gives excellent contrast, wide viewing angles and clear visibility for compact instruments, sensor nodes and handheld DIY devices. The board communicates using the I2C / IIC serial interface, reducing wiring to just four pins: GND, VCC, SCL/SCK and SDA. Only two microcontroller I/O lines are required for display data, making it easy to integrate with Arduino Uno, Nano, Mega, ESP8266, ESP32, STM32, Raspberry Pi Pico, 8051/51 development boards and other 3.3V or 5V logic systems. The SSD1306 driver is widely supported by common libraries such as Adafruit SSD1306, U8g2 and Arduino OLED libraries, allowing quick display of text, bitmaps, bar graphs, icons, menus and real-time sensor values. This 0.96 inch OLED screen is especially useful where space is limited but readable output is essential. Typical applications include temperature and humidity monitors, battery voltage meters, wearable prototypes, mini oscilloscopes, WiFi status displays, robotics dashboards, GPS trackers, electronic counters and embedded menu systems. The white display colour gives a clean professional look for dashboards and control panels. The module is supplied as a ready-to-use 4-pin OLED display board. Pin notes: connect GND to system ground, VCC to 3.3V or 5V supply, SCL/SCK to the I2C clock pin, and SDA to the I2C data pin. The I2C address is commonly 0x3C on these SSD1306 modules, but some batches may use 0x3D, so run an I2C scanner if the display is not detected immediately.